林业科学 ›› 2012, Vol. 48 ›› Issue (4): 97-101.doi: 10.11707/j.1001-7488.20120416
陈勇平1, 刘秀英1, 李华1, 韩扬2, 黎冬青2, 张涛2
Chen Yongping1, Liu Xiuying1, Li Hua1, Han Yang2, Li Dongqing2, Zhang Tao2
摘要:
以云杉原木圆盘为对象,研究不同面积、不同轮廓形状的空洞缺陷及用不同数量传感器情况时应力波成像技术检测缺陷图像与实际缺陷的关系。结果表明: 应力波成像系统可以直观显示木材内部缺陷,其检测精度与空洞等实际缺陷面积和被测木材的截面积比率、使用传感器数量及空洞等缺陷轮廓形状有关; 当空洞实际面积与被测木材截面积比从1.6%上升到25.0%时,应力波成像系统显示缺陷图像面积与实际缺陷面积相对误差从22.6%下降到9.7%; 成像用传感器数量在6~24个之间时,应力波成像系统均能显示空洞等缺陷的存在,但成像用传感器的数量会影响检测精度; 缺陷轮廓形状对应力波成像有一定影响,缺陷面积一定时,狭长形缺陷容易被检出,近圆形缺陷检测相对误差小。
中图分类号: