石膏-微米厚度刨花腕部骨伤固定夹板的制造工艺

doi:10.11707/j.1001-7488.20100428

林业科学 ›› 2010, Vol. 46 ›› Issue (4): 178-182.doi: 10.11707/j.1001-7488.20100428

• 研究简报 • 上一篇

石膏-微米厚度刨花腕部骨伤固定夹板的制造工艺

程瑞香¹ 马岩²

1.东北林业大学生物质材料科学与技术教育部重点实验室哈尔滨 150040; 2.东北林业大学林业与木工机械技术工程中心哈尔滨 150040

收稿日期:2008-08-05 修回日期:1900-01-01 出版日期:2010-04-25 发布日期:2010-04-25

Manufacture Technique of Splints of the Wrist Fracture Made of Plaster and Micron-Thickness Wood Particle

Cheng Ruixiang¹,Ma Yan²

1.Key Laboratory of Bio-Based Material Science and Technology of Ministry of Education, Northeast Forestry University Harbin 150040; 2.Forestry and Woodworking Machinery Engineering Center， Northeast Forestry University Harbin 150040

Received:2008-08-05 Revised:1900-01-01 Online:2010-04-25 Published:2010-04-25

摘要/Abstract

关键词: 腕部骨伤固定夹板, 微米厚度刨花, 石膏, 水膏比, 木膏比

Abstract:

This paper briefly introduces the characteristics of splints of the wrist fracture made of plaster and micron-thickness particle, and studies the optimum ratio of water and plaster, ratio of micron-thickness wood particle and plaster，too. The results showed that when the weight ratio of water and plaster was 0.6 and the weight ratio of wood and plaster was 0.15, the performance of the splints is comparatively good.

Key words: splints of the wrist fracture, micron-thickness particle, plaster, ratio of water and plaster, ratio of wood and plaster

程瑞香马岩. 石膏-微米厚度刨花腕部骨伤固定夹板的制造工艺[J]. 林业科学, 2010, 46(4): 178-182.

Cheng Ruixiang;Ma Yan. Manufacture Technique of Splints of the Wrist Fracture Made of Plaster and Micron-Thickness Wood Particle[J]. Scientia Silvae Sinicae, 2010, 46(4): 178-182.

石膏-微米厚度刨花腕部骨伤固定夹板的制造工艺

Manufacture Technique of Splints of the Wrist Fracture Made of Plaster and Micron-Thickness Wood Particle

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics

本文评价

作者中心

期刊获奖

引证指标

联系方式