木材渗透性可控制原理研究

›› 1992, Vol. 28 ›› Issue (4): 336-342.

木材渗透性可控制原理研究

鲍甫成吕建雄

中国林业科学研究院木材工业研究所

收稿日期:1991-04-20 修回日期:1900-01-01 出版日期:1992-07-25 发布日期:1992-07-25

A STUDY ON THE PRINCIPLE OF PERMEABILITY CONTROL OF WOOD

Bao Fucheng,Lǖ Jianxiong

Research Institute of Wood Industry, Chinese Academy of Forestry

Received:1991-04-20 Revised:1900-01-01 Online:1992-07-25 Published:1992-07-25

摘要/Abstract

摘要： 本文研究了木材渗透性可控制机制,探寻了渗透性可控制原理。结果表明,影响渗透性高低的最主要因素为纹孔膜微孔半径和数量,微孔大而多者,渗透性高;微孔愈小,微孔里气-液界面上毛细管张力愈高,对液体流动的影响愈大,浸注愈难,欲使浸注液深注入木材,必须施一与此微孔半径相应足以克服此张力的压力。若欲改善低渗透树种木材的难浸注性,似应从纹孔入手,用化学的、物理的和生物的等方法增大和增多有效纹孔膜微孔半径和数量,以减小毛细管张力,降低使用压力,增大流量率,提高渗透性。

关键词: 渗透性, 流量率, 气-液界面, 毛细管张力, 纹孔膜微孔

Abstract: The principle of permeability control of wood was studied. The results showed that the main factors affecting permeability of wood were the effective radius and the number of pit membrane openings. The permeability of wood which has large and many pit membrane openings is high. The smaller an opening is, the bigger the capillary tension at the gas-liquid interface in the opening is and the more difficult the impregnation of wood with liquid is. An impregnation pressure which is equal to the capillary tension at the gas-liquid interface in the pit membrane opening and enough to overcome the tension must be applied to the wood when the deep impregnation of wood with liquid is needed. One effective measure to improve the impregnation of wood seems to increase the radius of pit membrane openings and their number in order to reduce the capillary tension and the applied impregnation pressure, and subsequently to increase the flow rate and the permeability.

Key words: Permeability, Flow rate, Gas-liquid interface, Capillary tension, Pit membrane opening

鲍甫成吕建雄. 木材渗透性可控制原理研究[J]. , 1992, 28(4): 336-342.

Bao Fucheng;Lǖ Jianxiong. A STUDY ON THE PRINCIPLE OF PERMEABILITY CONTROL OF WOOD[J]. , 1992, 28(4): 336-342.

[1]	董晓璐, 孙耀星, 杜洪双, 赵雪, 蒋涛. 辊压预处理条件对蒙古栎干燥速率及纹孔结构的影响[J]. 林业科学, 2015, 51(1): 103-111.
[2]	徐康, 吕建雄, 李贤军, 吴义强, 刘元. 基于响应曲面优化法的木材高强微波预处理工艺[J]. 林业科学, 2014, 50(11): 109-114.
[3]	赵锦梅, 徐长林, 马亚萍, 李瑞. 祁连山东段高寒灌丛地被物与土壤的水文特征[J]. 林业科学, 2014, 50(10): 146-151.
[4]	张昌顺　范少辉　官凤英　刘广路　翁玉榛 . 闽北毛竹林的土壤渗透性及其影响因子[J]. 林业科学, 2009, 12(1): 36-42.
[5]	张耀丽蔡力平徐永吉. 蒸汽爆破后毛果冷杉湿心材的渗透性分析^*[J]. 林业科学, 2007, 43(09): 53-56.
[6]	江涛周志芳王清文. 高强度微波辐射对落叶松木材渗透性的影响[J]. 林业科学, 2006, 42(11): 87-92.
[7]	赵有科鲍甫成吕建雄. 溶剂置换材和气干材气体渗透性的比较研究[J]. 林业科学, 2003, 39(1): 114-118.
[8]	侯祝强鲍甫成. 针叶树材径向和弦向气体渗透的三维流阻网络[J]. 林业科学, 2002, 38(6): 93-98.
[9]	鲍甫成侯祝强. 针叶树材纵向气体渗透的三维流阻网络[J]. 林业科学, 2002, 38(4): 111-116.
[10]	鲍甫成侯祝强. 针叶树材管胞气体渗透流阻及其渗透系数[J]. 林业科学, 2001, 37(4): 80-87.
[11]	吕建雄鲍甫成姜笑梅赵有科. 3种不同处理方法对木材渗透性影响的研究[J]. 林业科学, 2000, 36(4): 67-76.
[12]	侯祝强鲍甫成. 木材可压缩流体的流动型态分析[J]. , 1999, 35(3): 63-68.
[13]	赵有科鲍甫成. 针叶树木材流体纵向渗透性与其构造关系的理论分析[J]. , 1998, 34(4): 88-95.
[14]	吕建雄鲍甫成姜笑梅周明. 汽蒸处理对木材渗透性的影响[J]. , 1994, 30(4): 352-357.
[15]	鲍甫成. 木材流体可渗性有效毛细管半径和数量的研究[J]. , 1993, 29(6): 521-530.