Welcome to visit Scientia Silvae Sinicae,Today is

Scientia Silvae Sinicae ›› 2011, Vol. 47 ›› Issue (1): 113-117.doi: 10.11707/j.1001-7488. 20110118

Previous Articles     Next Articles

Variation of Temperature inside the Mats for Wood-Based Panels by High-Frequency Hot Pressing Process

Chen Yongping, Wang Jinlin, Li Chunsheng, Wang Jinping   

  1. Key Laboratory of Wood Science and Technology of State Forestry Administration Research Institute of Wood Industry, CAF Beijing 100091
  • Received:2009-05-12 Revised:2009-06-29 Online:2011-01-25 Published:2011-01-25

Abstract:

In this paper, poplar were selected as the raw materials, melamine-formaldehyde resin(MF)was selected as adhesive, high-frequency hot pressing process was used to analyze the variation of temperature inside the mats for thick wood-based panels. The results showed the process of high-frequency hot pressing of the reconstituted lumber, power function was appropriated in describing the variation of temperatures inside the mats as a function of time. In length-width direction, the temperature may be different in heating process due to the moisture content. However, when the temperature surpass 100 ℃, temperature will gradually become stable. Along the direction of the thickness, the highest temperature was observed neither at the middle nor the surface layers of mats in high-frequency electric field, it occurred somewhere close to the positive plate, and the lowest temperature occurrrd near the negative plate.

Key words: poplar, melamine-formaldehyde resin(MF), high-frequency, hot pressing, temperature, power

CLC Number: