欢迎访问林业科学,今天是

›› 1985, Vol. 21 ›› Issue (2): 113-121.

• 论文及研究报告 •    下一篇

几种固沙植物对沙土影响的研究

王永魁   

  1. 辽宁省固沙造林研究所
  • 收稿日期:1900-01-01 修回日期:1900-01-01 出版日期:1985-05-25 发布日期:1985-05-25

OBSERVATIONS ON THE EFFECT OF SOME SAND-FIXING PLANTS ON THE SANDY SOIL

Wang Yongkui   

  1. The Sand-Fixation Afforestation Research Institute of Liaoning Province
  • Received:1900-01-01 Revised:1900-01-01 Online:1985-05-25 Published:1985-05-25

摘要: 本文就黄柳(Salix,flivida Chang et Skv.)差巴戛蒿(Artemisia halode-ndron Turcz.)胡枝子(Lspedeza bicolor Turcz.)锦鸡儿(Caraganamicrophylla Lam.)山竹子(Hedysarum mongolicum Turcz.)等植物固沙后对沙土的影响进行了调查研究。认为:流沙经植物固定后,由于风速降低、风蚀减弱,沙面有大量枯落物堆积,其中以黄柳固沙区最多(3.5—3.9t/ha),差巴戛蒿等固沙区最少(0.31t/ha)。沙土表层机械组成变细,粉沙以下部分增加,容重变小,孔隙度加大,养分条件有所改善,腐殖质、氮、钾的含量增加,尤以钾的含量增加较快。由于固沙植物对水分的消耗,沙土水分含量有不同程度的减少,因此当流沙经植物固定2—3年后,即应及时造林,并适当扩大造林树种的株行距离。以免影响造林树种的成活、生长。

Abstract: The observations on the effect of some sand-fixing plants,which were Salix flavida Chang et Skv.,Artemisia halodendron Turcz.,Lespedeza bicolor Turcz.,Caragana microphylla Lam.,and Hedysarum mongolicumTurcz.,on sandy soil were made.It was observed that sand movements was stoped efficiently by these plants.The velocity of wind within the plantations was greatly reduced so that soil erosion became rather weak and lots of litter was accumulated on the ground under the plants.There were the greatest quantity of litter accumulated in the plantation of S.flavida with 3.5—3.9 tons per hectare and the least in the plantation of A.halodendron with 0.31 tons per hectare. It could be seen clearly on the texture profile that the mechanical structure of the top layer and the volume weight became finer and lighter respectively.The nutrient condition of soil was much improved with marked increases in humus and some nutritional elements such as nitrogen and potassium,especially in the content of potassium obviously increased. Tree plantations should be established within 2 or 3 years after dunes stabilized by the plants mentioned above and a little attention should be paied to the espacement,which could be designed larger than the normal.